Automatic release of EPB

The EPB is released automatically under following conditions.

Gear in P (Park)

With the engine running engage the brake pedal and shift out of P (Park) to R (Reverse) or D (Drive).

(if Shift Lever is equipped)
Gear in N (Neutral)

With the engine running engage the brake pedal and shift out of N (Neutral) to R (Reverse) or D (Drive).

(if Shift Lever is equipped)
Automatic transmission
1. Start the engine.
2. Fasten the driver's seat belt.
3. Close the driver's door, hood and tailgate.
4. Press the accelerator pedal while the gear is in R (Rear), D (Drive) or manual mode.

Make sure the brake warning light goes off.

NOTICE

For your safety, you can engage the EPB even though the ENGINE START/STOP button is in the OFF position, but you cannot release it.
For your safety, press the brake pedal and release the parking brake manually with the EPB switch when you drive downhill or when backing up the vehicle.

Do not follow the above procedure when driving on a flat level ground. The vehicle may suddenly move forward.

NOTICE

If the parking brake warning light is still on even though the EPB has been released, have the system checked by a professional workshop. Kia recommends to visit an authorized Kia dealer/ service partner.

CAUTION

Do not drive your vehicle with the EPB applied. It may cause excessive brake pad and brake rotor wear.