Front windshield wiper blade

For your convenience, move the windshield wiper blades to the service position as follows;
After turning off the engine, move the wiper switch to the single wiping (MIST) position within 20 seconds and hold the switch more than 2 seconds until the wiper blade is in the fully up position.
Do not allow the wiper arm to fall against the windshield, since it may chip or crack the windshield.
-
Raise the wiper arm.
-
Lift up the wiper blade clip (1). Then pull down the blade assembly (2) and remove it.
ODEEV098016NR -
Install the new blade assembly.
ODEEV098017NR -
Return the wiper arm on the windshield.
-
Turn ignition to the ON position and wiper arms will return to the normal operating position.
Type B
-
Raise the wiper arm and turn the wiper blade assembly to expose the plastic locking clip.
OBD071205 -
Compress the clip and slide the blade assembly downward.
OBD071206
1JBA7038 -
Lift it off the arm.
-
Install the new blade assembly.
-
Return the wiper arm on the windshield.
-
Turn ignition to the ON position and wiper arms will return to the normal operating position.