Jump-starting

  1. Make sure the booster battery is 12-volt and that its negative terminal is grounded.

    If the booster battery is in another vehicle, do not allow the vehicles to come in contact.

  2. Turn off all unnecessary electrical loads.
  3. Connect the jumper cables in the exact sequence shown in the illustration.
    1. Open the engine room fuse panel cover located in the engine compartment. Connect on end of a jumper cable to the charging terminal inside the engine compartment fuse panel (1).
    2. Connect the other end to the positive terminal of the booster battery (2).
    3. Proceed to connect one end of the other jumper cable to the negative terminal of the booster battery (3), then the other end to a solid, stationary, metallic point away from the battery (4).

      Do not allow the jumper cables to contact anything except the correct battery terminals or the correct ground. Do not lean over the battery when making connections.

  4. If connected with the other vehicle, start the vehicle with the booster battery first and let it run at 2,000 rpm for several minutes.
  5. Start the vehicle with the discharged battery.
  6. If the engine starts, disconnect one end of the negative terminal of the booster battery (3), then other end of the positive terminal of the booster battery (2) and the charging terminal inside the engine compartment fuse panel (1).

If the cause of your battery discharging is not apparent, you should have your vehicle checked by a professional workshop. Kia recommends to visit an authorized Kia dealer/service partner.

CAUTION

After checking the fuse panel in the engine compartment, securely install the fuse panel cover through the audible clicking sound.

If not, electrical failures may occur from water contact.

NOTE

Battery cables

Do not connect the jumper cable from the negative terminal of the booster battery to the negative terminal of the discharged battery. This can cause the discharged battery to overheat and crack, releasing battery acid.

Make sure to connect one end of the jumper cable to the negative terminal of the booster battery, and the other end to a metalic point, far away from the battery.