Daytime Running Light (DRL)

The Daytime Running Lights (DRL) can make it easier for others to see the front of your vehicle during the day, especially after dawn and before sunset. The Daytime Running Lights (DRL) should be illuminated whenever you are driving during daylight hours. The DRL system will be ON when the headlamp stalk is in the OFF or the AUTO Position (when daylight is detected) and the Electronic Parking Brake (EPB) is released.

Non-operating conditions

  • When engine is not started

  • When the engine is started with the parking brake applied (before driving)

  • When the headlights are on

    • However, the headlights are turned on automatically at night in the AUTO position of the light switch.

  • When the front fog light is on

TIP

If necessary, to keep the position lamp on when the vehicle is turned off, perform the following:

  • Open the driver’s side door.

  • Turn the position lamp ON.

NOTE
  • Traffic Change (For Europe)

    The low beam light distribution is asymmetric. If you go abroad to a country with opposite traffic direction, this asymmetric part will dazzle oncoming car driver. To prevent dazzle, ECE regulation demand several technical solutions (ex. automatic change system, adhesive sheet, down aiming). These headlamps are designed not to dazzle opposite drivers.

    But if Intelligent Front-lighting System equipped, you need to adjust Travel Mode in infotainment system when in a country with opposite traffic direction. Select the Travel mode, Setup > Vehicle > Lights > Travel Mode from the infotainment system.

  • You can disable the daytime running lights by engaging the brakes with the headlights on and turning off the headlights.