High Beam Assist limitations

High Beam Assist may not work properly in the following situations:

  • Light from another vehicle is not detected for any reason.

  • The lamp of an oncoming vehicle or a vehicle ahead is damaged or outside the detection range.

  • The headlights are dirty with dust, snow, or water.

  • The headlight is off but the fog light is on.

  • An oncoming vehicle or a vehicle ahead has its headlights turned off and its fog lights turned on.

  • Your vehicle detects a lamp that is shaped like a vehicle headlight.

  • The headlamps are damaged or incorrectly repaired.

  • The headlamps are not aimed properly.

  • You are driving on a narrow, curved, rough, or steep road.

  • You are driving on a crossroad or curved road and a vehicle in front of you is partially visible.

  • There is a traffic light, reflective or flashing sign, or mirror ahead.

  • There is a temporary reflector or flash ahead from a construction area.

  • Road conditions are wet, icy, snowy, or otherwise poor.

  • A vehicle suddenly appears from around a curve.

  • A vehicle is tilted because of a flat tire or is being towed.

  • Light from a vehicle is not detected because of exhaust fumes, smoke, fog, snow, or other obstructions.

NOTE

For detailed limitations of the front camera sensor, refer to Limitations of Forward Collision-Avoidance Assist

TIP
  • The High Beam Assist function is only for your convenience and may not work properly at times. It is the responsibility of the driver to maintain safe driving practices and always watch the road.

  • High Beam Assist may not operate for 15 seconds after you start the vehicle or after you initialize or restart the front view camera.

  • When High Beam Assist does not operate normally, manually switch the headlights between high and low beam.