Front wiper blade replacement (Type B)

To replace the front wiper blade, follow these steps:

NOTE

Wiper arms

  • Do not allow the wiper arm to fall against the windshield, as it may crack or chip the glass.

  • Do not pull the wiper arm forward, as the arm could chip the hood paint.

  1. For your convenience, and to prevent hood paint damage, move the windshield wiper blades to the service position.
  2. Make sure the vehicle is in the OFF position and disconnect battery connector.
  3. Move the wiper switch to the single wiping (MIST) position within 20 seconds.
OSG2H126049L
  1. Hold the switch for more than 2 seconds until the wiper blades are pointing straight up.
  2. Raise the wiper arm.
  3. Lift the wiper blade clip up (1).
    OSG2H126019L
  4. Pull down the blade assembly and remove the clip (2).
    OSG2H126019L
  5. Install the new blade assembly.
    OSG2H126020L
  6. Return the wiper arms to the windshield.
  7. Start the vehicle to the ON position.
  8. Operate the wiper once in the MIST position to check that it operates properly.