Replacing the rear wiper blade

OSV074047L_3

Operation

  1. Turn off the vehicle.

  2. Move the wiper switch to the single wiping (MIST/1x) position within 20 seconds.

  3. Hold the wiper switch for more than 2 seconds.

  4. Raise the wiper arm.

  5. Hold the wiper arm, press the wiper blade button, and pull it downward to remove it.

  6. Install the new blade assembly by inserting the centre part into the slot in the wiper arm until it clicks into place.

  7. Upon starting the vehicle, the wiper arms will return to their normal operating position.

TIP

To prevent damage to the wiper arms or other components, have the wiper blade replaced by a professional workshop. Kia recommends visiting an authorised Kia dealer/service partner.

CAUTION

  • Do not use petrol, kerosene, paint thinner, or other solvents on or near them.

  • Do not attempt to move the wipers manually.

  • The use of a non-specified wiper blade could result in wiper malfunction and failure.

  • Do not allow the wiper arm to fall against the windscreen, since it may chip or crack the windscreen.

  • If the wiper arm receives too much force whilst pulling the blade, the centre part may be damaged.

  • The wiper could not operate for approximately 10 seconds when the wiper is operated without washer fluid or the blades are frozen. This is not a malfunction, it is a wiper protection system activated by motor overload circuit within the wiper motor.

  • The front windscreen should be cleaned with water hose and wiped with clean towel with wiper blades raised up. Also, the wiper blades should be wiped clean when the grease or wax is applied to the blades.

NOTE

Commercial hot waxes applied by automatic car washes have been known to make the windscreen difficult to clean. And it is the responsibility of customers to wash and manage the vehicle with adequate methods and materials.