The sunroof may need to be reset if the following conditions occur:

The battery is discharged or disconnected or the sunroof fuse has been replaced or disconnected.
The sunroof control lever is not operating correctly.

To reset the sunroof, perform the following steps:

Place the ignition switch to the ON position or start the engine. It is recommended to reset the sunroof whilst the engine is running.
Push the control lever forward. The sunroof will close completely or tilt depending on the condition of the sunroof.
Release the control lever when the sunroof stops moving.
Push the control lever forward for about 10 seconds.
- When the sunroof is in the closed position, the glass will tilt and slightly move up and down.
- When the sunroof is in the tile position, the glass will slightly move up and down.
Do not release the lever until the operation is completed. If you release the lever during operation, try again from step 2.
Within 3 seconds, push the control lever forward until the sunroof operates as follows:

Tilt down → Slide open → Slide close.

Do not release the lever until the operation is completed. If you release the lever during operation, try again from step 2.
Release the sunroof control lever after all operation has completed. (The sunroof system has been reset.)