Replacing the back up lamp (Bulb type)
![]() P_CD27_D12_057_E |
|
- Make sure the vehicle is in the OFF position and disconnect the negative 12V battery terminal.
- Use a slotted (flat-tip) screwdriver to loosen the plastic tabs.
- Loosen the plastic retaining screws and open the underpanel cover.
- Disconnect the rear reversing lamp connector.
- To remove the socket from the assembly, turn the socket counterclockwise until the tabs on the socket align with the slots on the assembly.
- To install the socket back into the assembly, align the tabs on the socket with the slots in the assembly, push the socket into the assembly, and turn the socket clockwise.
- Reconnect the rear reversing lamp connector.
- Tighten the plastic retaining screws.
- Close the underpanel cover and replace the plastic tabs.
