If you have a flat tyre (with Tyre Mobility Kit)
The Tyre Mobility Kit (TMK) is a temporary fix to the tyre and the tyre should be inspected by an authorised Kia dealer or service partner as soon as possible.
![]() N_QVe27_D11_004_1_E |
|
The TMK is located in the cargo area or in a dedicated bag in the tailgate on the side trim.
For safe operation, carefully read and follow the instructions in this manual before use.
-
Do not use the TMK to repair large punctures or damage to the tyre sidewalls. In these situations, the tyre will not be fully sealed and air will leak from the tyre. This can result in tyre failure.
-
Have your tyre repaired as soon as possible. The tyre may lose air pressure at any time after inflating with the TMK.
-
Do not exceed a speed of 80 km/h (50 mph) when driving with a tyre sealed with the TMK.
Whilst driving, if you experience any unusual vibration, ride disturbance, or noise, reduce your speed and drive with caution until you can safely pull off to the side of the road.
When two or more tyres are flat, do not use the TMK because the supplied canister of sealant in the TMK is only enough sealant for one flat tyre.
Introduction
With the TMK properly used, the vehicle can be operated even after experiencing a tyre puncture.
The system of compressor and sealing compound effectively seals most punctures (from nails or similar objects) and reinflates the tyre.
After you ensure that the tyre is properly sealed, drive cautiously at a maximum speed of 80 km/h (50 mph) to reach a service station or tyre dealer to replace the tyres.
Air pressure loss may adversely affect tyre performance.
For this reason, you should avoid abrupt steering or other driving manoeuvres, especially if the vehicle is heavily loaded or a trailer is in use.
The TMK is not intended as a permanent tyre repair method and is to be used for one tyre only.
This instruction shows you step by step procedures to temporarily seal the puncture.
Read the section below.
Notes on the safe use of the Tyre Mobility Kit
-
Park your car on the side of the road so that you can use the TMK away from moving traffic.
-
Be sure your vehicle cannot move. Even when on fairly level ground, always set the parking brake.
-
Only use inflating TMK for sealing/inflating vehicle tyres. Only punctured areas located within the tread region of the tyre can be sealed using the TMK.
-
Do not use on motorcycles, bicycles or any other type of tyres.
-
When the tyre and wheel are damaged, do not use TMK for your safety.
-
TMK may not be effective for tyre damage larger than approximately 4 mm (0.16 inches).
Please contact the nearest Kia dealership if the tyre cannot be made roadworthy with the Tyre Mobility Kit.
-
Do not use the TMK if a tyre is severely damaged by driving with flat tyres or with insufficient air pressure.
-
Do not remove any foreign objects such as nails or screws that have penetrated the tyre.
-
If the vehicle is outdoors, leave the vehicle on. Otherwise operating the compressor may eventually drain the 12V battery.
-
Never leave the TMK unattended whilst it is being used.
-
Do not leave the compressor running for more than 10 minutes at a time or it may overheat.
-
Do not use the TMK if the ambient temperature is below -30 °C (-22 °F).
-
If sealant gets on your skin, wash it with a lot of water. If skin irritation continues, visit a doctor.
-
If sealant gets in your eyes, lift up your eyelid and wash for at least 15 minutes. If eye irritation continues, visit a doctor.
-
If sealant is swallowed, wash the mouth and drink a lot of water. However, do not give anything to an unconscious person and see a doctor immediately.
Exposure to the sealant for a long time may cause damage to bodily tissues.
When done using a flat tyre with the TMK, quickly remove the sealant from the tyre pressure sensor and wheel. When installing the repaired tyre and wheel, tighten the wheel nut to a torque value of 11–13 kgf·m (79–94 lbf·ft).
-
Take out the remover tool in the Tyre Mobility Kit. Insert the tool to the hole and pull out the wheel cover.
-
When removing the wheel cover, if you use any other tool except the tool provided, the wheel cover may be damaged.
![]() N_QVe27_D11_005_1_E |

