Using the Tyre Mobility Kit

Operation

  1. Shake the sealant bottle.

    OSV064020

  2. Connect the compressor hose to the compressor hose connector, located on the sealant bottle (1). Make sure the sealant bottle is sitting upright.

    OSV064021

  3. Unscrew the valve cap of the damaged tyre and screw the sealant bottle filling hose onto the tyre valve.

    OSV064012
    NOTE

    Make sure the compressor pressure regulating valve is closed.

    OSV064011

  4. Make sure the compressor is turned off, then connect the power outlet connector.

    OSV064013R

  5. Start the vehicle, turn on the compressor, and run for approximately 5-7 minutes before injecting the sealant.

  6. Inject the sealant to ensure recommended tyre air pressure. Check and adjust the tyre pressures later. For the recommended air pressure, Refer to the Tyres and wheels.

  7. Turn off the compressor and disconnect the sealant bottle's injection hose from the tyre.

  8. After using it, leave the TMK (Tyre Mobility Kit) in place in the vehicle with the injection hose in the sealant bottle side and the injection hose in the compressor side assembled.