Window opening and closing
You can open and close windows using the power window switch.
Type A
![]() OMQ4033037 |
To open or close a window, press down or pull up the front portion of the corresponding switch to the first detent position (5).
Type B - Auto up/down window : (if equipped)
![]() OMQ4033036 |
Momentarily pressing down or pulling up the power window switch to the second position (2) completely lowers or raises the window, even when you release the switch. To stop the window at the desired position while it is moving, pull up or press down and release the switch.
To reset the power windows
If the power window does not operate normally, reset the automatic power window system as follows:
-
Turn the ignition switch or ENGINE START/STOP button to the ON position.
-
Close the window and continue pulling up the power window switch for at least 1 second after the window is completely closed.
Automatic reversal : (if equipped)
![]() OGL3061066L |
If the upward movement of the window is blocked by an object or part of the body, the window will detect the resistance and will stop upward movement. The window will then lower approximately 30 cm (11.8 inches) to allow the object to be cleared.
If the window detects the resistance while the power window switch is pulled up continuously, the window will stop upward movement then lower approximately 2.5 cm (1 inch).
And if the power window switch is pulled up continuously again within 5 seconds after the window is lowered by the automatic window reversal feature, the automatic window reversal will not operate.
The automatic reverse feature for the window is only active when you use the “auto up” feature by fully pulling up the switch. The automatic reverse feature will not operate if you raise the window using the halfway position on the power window switch.
Always check for obstructions before raising any window to avoid injuries or vehicle damage. If an object less than 4 mm (0.16 inch) in diameter is caught between the window glass and the upper window channel, the automatic reverse window may not detect the resistance and will not stop and reverse direction.
The automatic reverse feature is not activated while resetting power window system.
Make sure body parts or other objects are safely out of the way before closing the windows to avoid injuries or vehicle damage.


