Windshield washer operation
![]() OMQ4PH034038 |
|
![]() OMQ4PH033038L |
|
![]() OMQ4033499R |
-
Move the wiper speed control switch to In OFF (0) position.
-
Gently pull the lever toward you to spray washer fluid on the windshield and run the wipers 1–3 cycles when the windshield is dirty. The spray and wiper operation will continue until you release the lever.
If the washer does not work, check the washer fluid level. If the fluid level is not sufficient, you will need to add appropriate non-abrasive windshield washer fluid to the washer reservoir.
The reservoir filler neck is located in the front of the engine compartment on the passenger side.
To prevent possible damage to the washer pump, do not operate the washer when the fluid reservoir is empty.
Do not use the washer in freezing temperatures before warming the windshield with the defroster, as the washer solution could freeze on the windshield and obscure your view.
-
To prevent possible damage to the wipers or windshield, do not operate the wipers when the windshield is dry.
-
To prevent damage to the wiper blades, do not use gasoline, kerosene, paint thinner, or other solvents on or near the wiper blades.
-
To prevent damage to the wiper arms and other components, do not attempt to move the wipers manually.
-
To prevent possible damage to the wipers and washer system, use anti-freezing washer fluids in the winter season or cold weather.


