Canceling Highway Lane Change Assist
Highway Lane Change Assist is canceled when:
-
The turn signal lever is turned on in the opposite direction of lane change
-
You turn the steering wheel too sharply.
-
You turn the turn signal lever to the (1) position while Lane Change Assist is operating, then return the turn signal lever to the neutral position before you change lanes.
-
While the function is operating, the function will cancel if one of the following occurs:
-
You turn Highway Driving Assist OFF.
-
You turn OFF or temporarily cancel Lane Following Assist or Smart Cruise Control.
-
Hands-off warning message is displayed on the cluster
-
The turn signal lever is placed at A position
-
You turn the hazard lights ON.
-
Forward Collision-avoidance Assist or Blind-spot Collision-avoidance Assist warning message is displayed
-
Possible collision is detected in the next lane, even though there are no Forward Collision-avoidance Assist and Blind Spot Collision-avoidance Assist warning
-
Entering a road under construction
-
The target lane to make a lane change disappears
-
The target lane to make a lane change is not detected
-
There is a problem with turn signal lamps
-
Highway Lane Change Assist function is off (The function turns off when the function is turned off from the settings menu, when the road changes to a one-way road, when there is an intersection or crosswalk ahead, when you enter a road with no structure, such as a medium strip, guardrail, etc., or when there is a pedestrian or cyclist on the driving lane.)
-
If the driving speed slows down to less than 25 km/h (15 mph) when it is in ready state, it will change to standby state.
-
When driving at low speeds, the vehicle will change to standby state if it is not recognized by the vehicles in the left and right adjacent lanes.
Low speeds (Australia): 30–60 km/h (20–40 mph)
Low speeds (Europe): 30–80 km/h (20–50 mph)
-
Your vehicle detects a risk of collision.
-
-
While the function is operating, when the function is canceled, depending on the driving conditions, the vehicle may drive to the middle of the driving lane or steering assist may stop. Always pay attention to road and driving conditions while driving.
-
The function may not operate normally on roads with pedestrians or cyclists, such as an intersection or crosswalk. Always pay attention to road and driving conditions while driving.