Display and control

• After selecting HBA in the Settings menu, High Beam Assist will operate by following the procedure below:

  • Place the headlamp switch in the AUTO position and push the headlamp lever towards the instrument cluster. The HBA ( ) indicator light will appear on the cluster and the function will be enabled.

  • When the function is enabled, the high beam will turn on when vehicle speed is above 20 mph (30 km/h). When vehicle speed is below 12 mph (20 km/h), the high beam will not turn on.

  • The High Beam ( ) indicator light will appear on the cluster when high beam is on.

• When HBA is operating, if the headlamp lever or switch is used, the function operates as follows:

  • If the headlamp lever is pulled towards you when the high beam is off, the high beam will turn on without HBA canceled. When you let go of the headlamp lever, HBA will turn on again.

  • If you push the light switch towards the instrument cluster, high beam is turned on and HBA is released.

  • If the headlamp lever is pulled towards you when the high beam is on via HBA, the low beam will be on and the function will turn off.

  • If the headlamp switch is placed from AUTO to another position (headlamp/position/off), HBA will turn off and the corresponding lamp will turn on.

• When HBA is operating, high beam switches to low beam if any of the following conditions occur:

  • When the headlamps of an oncoming vehicle are detected.

  • When the taillamp of a vehicle in front is detected.

  • When the headlamp or taillamp of a motorcycle or a bicycle is detected.

  • When the surrounding ambient light is bright enough that high beams are not required.

  • When streetlights or other lights are detected.