Auto defogging system (ADS)
Auto defogging helps reduce the possibility of fogging up the inside of the windshield by automatically sensing the moisture on inside the windshield.
When the ADS operates, the indicator will appear.
If a high amount of humidity is detected in the vehicle, the ADS will be enabled.
The following steps will be performed automatically:
To cancel or reset the ADS
Press the front windshield defroster button for 3 seconds when the ignition switch or ENGINE START/STOP button is in the ON position.
When the ADS is canceled, the defrost button indicator will blink 3 times.
When the ADS is reset, the defrost button indicator will blink 6 times without a signal.
-
When the air conditioning is turned on by ADS, if you try to turn off the air conditioning, the indicator will blink 3 times and the air conditioning will not be turned off.
-
To maintain the effectiveness and efficiency of the ADS, do not select Recirculation mode while the system is operating.
-
When the ADS is operating, the fan speed adjustment knob, the temperature adjustment knob, and the air intake control button are all disabled.
Do not remove the sensor cover located on the upper end of the driver side windshield glass.
Damage to system parts could occur and may not be covered by your warranty.