Auto defogging system (only for automatic climate control system, if equipped)
Auto defogging helps reduce the possibility of fogging up the inside of the windshield by automatically sensing the moisture on inside the windshield.
When the Auto Defogging System operates, the indicator will illuminate.
If high of humidity is detected in the vehicle, the Auto Defogging System will be enabled.
The following steps will be performed automatically:
-
The A/C button will turn ON.
-
The air intake control will change to Fresh mode under low outside temperature.
-
The mode will be changed to defrost to direct airflow to the windshield.
-
The fan speed will be increased.
To cancel or reset the Auto Defogging System
Press the front windshield defroster button for 3 seconds when the ignition switch or ENGINE START/STOP button is in the ON position.
When the Auto Defogging System is canceled, the defrost button indicator will blink 3 times.
When the Auto Defogging System is reset, the defrost button indicator will blink 6 times.
-
If you try to turn off the air conditioning when the air conditioning is turned on by the Auto defogging system, the indicator will blink 3 times. The air conditioning will not be turned off.
-
To maintain the efficiency of the Auto Defogging System, do not select Recirculation mode while the system is operating.
-
When the Auto Defogging System is operating, the fan speed adjustment knob, the temperature adjustment knob, and the air intake control button are all disabled.
Do not remove the sensor cover located on the upper end of the driver side windshield glass.
Damage to system parts could occur and may not be covered by your warranty.