• Once you set the ignition switch or ENGINE START/STOP button to the ON position.

  • It illuminates for approximately 3 seconds and then goes off.

• When there is a malfunction with the ESC system.

  In this case, have the vehicle inspected by a professional workshop. Kia recommends to visit an authorized Kia dealer/service partner.

While the ESC is operating.

* For more details, refer to More Details.

• Once you set the ignition switch or ENGINE START/STOP button to the ON position.

  • It illuminates for approximately 3 seconds and then goes off.

• When you deactivate the ESC system by pressing the ESC OFF button.

* For more details, refer to More Details.

• When the vehicle detects the immobilizer in your key properly while the ignition switch is ON.

  • At this time, you can start the engine.

  • The indicator light goes off after starting the engine.

• When there is a malfunction with the immobilizer system.

  In this case, have the vehicle inspected by a professional workshop. Kia recommends to visit an authorized Kia dealer/service partner.

• When the vehicle detects the smart key in the vehicle properly while the ENGINE START/STOP button is ACC or ON.

  • At this time, you can start the engine.

  • The indicator light goes off after starting the engine.

• When the smart key is not in the vehicle.

  • At this time, you can not start the engine.

• When the vehicle can not detect the smart key which is in the vehicle while the ENGINE START/STOP button is ON.

  In this case, have the vehicle inspected by a professional workshop. Kia recommends to visit an authorized Kia dealer/service partner.

• When the battery of the smart key is weak.

  • At this time, you can not start the engine. However, you can start the engine if you press the ENGINE START/STOP button with the smart key. (For more details, refer to More Details).

• When there is a malfunction with the immobilizer system.

  In this case, have the vehicle inspected by a professional workshop. Kia recommends to visit an authorized Kia dealer/service partner.

• When you turn the turn signal light on.

If any of the following occurs, there may a malfunction with the turn signal system. In this case, have the vehicle inspected by a professional workshop. Kia recommends to visit an authorized Kia dealer/service partner.

• The indicator light does not blink but illuminates.

• The indicator light blinks more rapidly.

• The indicator light does not illuminate at all.

• When the headlights are on.

• When the headlights are on and in the high beam position.

• When the turn signal lever is pulled into the Flash-to-Pass position.

• When the high beam is on with the light switch in the AUTO light position.

• If your vehicle detects oncoming or preceding vehicles, High Beam Assist will switch the high beam to low beam automatically.

* For more details, refer to More Details.

• When the tail lights or headlights are on.

• When the front fog lights are on.

• When the rear fog lights are on.

• When changing gear position without pressing brake pedal.

• When trying to start the engine without pressing brake pedal.

• When the engine is turned off without engaging parking brake lever, it illuminates for approximately 5 seconds then goes off.

• When Cruise Control is enabled.

• When Cruise Control speed is set.

• [Green] When Lane Keeping Assist operating conditions are satisfied.

• [White] When Lane Keeping Assist operating conditions are not satisfied.

• [Yellow] When Lane Safety is deselected, disabled, or a malfunction is detected.

  In this case, have the vehicle inspected by a professional workshop. Kia recommends to visit an authorized Kia dealer/service partner.

The indicator light blinks:

• Green: When Lane Keeping Assist is operating.

This warning light illuminates, when accumulated soot reaches a certain amount.

With the GPF warning light on, the warning light turns off under the following conditions:

• You drive over 100 km/h (60 mph).

• Your vehicle's engine speed is between 2,500 and 4,000 rpm.

• You drive in third gear or higher.

  • For your safety, be sure to adjust to the above conditions on a road that is not congested.

  • Accelerate up to 2500-4000 rpm and 100 km/h (60 mph) in third gear or higher and release the accelerator pedal and wait for at least 10 seconds.

  • Repeat this process until the GPF warning light turns off.

If this warning light blinks in spite of the procedure (at this time the LCD warning message will be displayed), have the GPF system checked by a professional workshop. Kia recommends to visit an authorized Kia dealer/service partner.