Replacing reversing lamp (bulb type)

OMQ4035555
  1. Press the ENGINE START/STOP button in the OFF position and disconnect the battery’s negative (-) terminal.

  2. Remove the plastic tabs with a flat-tip screw driver.

  3. Loosen the plastic retaining screws and remove the under panel cover.

  4. Disconnect the rear reversing lamp connector.

  5. To remove the socket from the assembly, turn the socket counterclockwise until the tabs on the socket align with the slots on the assembly.

  6. Press the bulb in to the socket and rotate it counterclockwise until the tabs on the bulb align with the socket. Then, remove the bulb from the socket.

  7. Insert a new bulb by inserting it into the socket and rotating it until it locks into place.

  8. To install the socket back into the assembly, align the tabs on the socket with the slots in the assembly, push the socket into the assembly, and turn the socket clockwise.

  9. Reconnect the rear reversing lamp connector.

  10. Tighten the plastic retaining screws.

  11. Install the plastic tabs and the under panel cover.