Search by Title only
Home > What to do in an emergency > If you have a flat tire (with Tire Mobility Kit) > Checking the tire inflation pressure

Checking the tire inflation pressure

  1. After driving approximately 7~10 km (4~6 miles) or about 10 minutes, stop at a suitable location.

  2. Connect the filling hose (3) of the compressor (clip mounted side) directly and then connect the filling hose (3) (opposite side) to the tire valve.

  3. Connect between compressor and the vehicle power outlet using the cable and connectors.

  4. Adjust the tire inflation pressure to 200 kPa (29 psi). With the ignition switch or ENGINE START/STOP button ON position, proceed as follows.

    • To increase the inflation pressure: Switch on the compressor, position I. To check the current inflation pressure setting, briefly switch off the compressor.

      WARNING

      Do not let the compressor run for more than 10 minutes, otherwise the device will overheat and may be damaged.

    • To reduce the inflation pressure: Press the button (9) on the compressor.

      WARNING

      The tire inflation pressure must be at least 200 kPa (29 psi, 2 bar). If it is not, do not continue driving.

      Call for road side service or towing.