Trip information (trip computer) (For Type B cluster)
The trip computer is a microcomputer- controlled driver information system that displays information related to driving.

Some driving information stored in the trip computer resets if the battery is disconnected.
Trip Modes

To change the trip mode, scroll the toggle the switch ( /
) on the steering wheel.
Drive Info mode
This display shows the trip distance (1), the total driving time (2), and the average fuel efficiency (3) information once per one ignition cycle.

A: Current Trip
-
Fuel efficiency is calculated after the vehicle has run for more than 300 meters (0.2 miles).
-
The Driving Information will be reset 4 hours after ignition has been turned off. So, when the vehicle ignition is turned on within 4 hours, the information will not be reset.
-
If you press "OK" button for more than 1 second after the Driving Information is displayed, the information will be reset.
-
If the engine is running, even when the vehicle is not in motion, the information will be accumulated.
Fuel economy

A: Current Trip
-
Accumulated trip distance
-
Total driving time
-
Average fuel efficiency
-
The average fuel economy is calculated by the total driving distance and fuel consumption since the last average fuel economy reset.
-
Fuel economy range: 0.0 ~ 99.9 L/100km, km/L or MPG
-
-
The average fuel economy can be reset both manually and automatically.
-
Manual reset
To clear the average fuel economy manually, press the OK button on the steering wheel for more than 1 second when the average fuel economy is displayed.

The average fuel economy is not displayed for more accurate calculation if the vehicle does not drive more than 10 seconds or 300 meters (0.2 miles) since the ignition switch or ENGINE START/STOP button is turned to ON.
-
This mode displays the instant fuel economy during the last few seconds when the vehicle speed is more than 8 km/h (5 mph).
-
Fuel economy range:
0 ~ 30 L/100km, km/L or 0 ~ 50 MPG
-
Accumulated driving information mode
This display shows the accumulated trip distance (1), the total driving time (2), and the average fuel efficiency (3).

A: Since Last Reset
-
Accumulated information is calculated after the vehicle has run for more than 300 meters (0.2 miles).
-
If you press "OK" button for more than 1 second after the Cumulative Information is displayed, the information will be reset.
-
If the engine is running, even when the vehicle is not in motion, the information will be accumulated.
Service interval
This reminds you of scheduled maintenance information.

Service in
It calculates and displays when you need a scheduled maintenance service (mileage or days).
If the remaining mileage or time reaches 1,500 km (900 miles) or 30 days, "Service in" message is displayed for several seconds each time you set the ignition switch or ENGINE START/STOP button to the ON position.
Service required
If you do not have your vehicle serviced according to the already inputted service interval, "Service required" message is displayed for several seconds each time you set the ignition switch or ENGINE START/STOP button to the ON position.
To reset the service interval to the mileage and days you inputted before:
-
Press the OK button (Reset) for more than 1 second.

If any of the following conditions occurs, the mileage and days may be incorrect.
-
The battery cable is disconnected.
-
The battery is discharged.