Limitations of High Beam Assist

High Beam Assist might not work properly in the following situations:

  • Light from another vehicle is not detected for any reason.

  • Headlamp of a vehicle is covered with dust, snow or water.

  • A vehicle’s headlamps are off but the fog lamps are on and etc.

  • Your vehicle detects a lamp that is shaped like a vehicle headlight.

  • Headlamps have been damaged or not repaired properly.

  • Headlamps are not aimed properly.

  • You are driving on a narrow, curved, rough, or steep road.

  • You are driving on a crossroad or curved road and a vehicle in front of you is partially visible.

  • There is a traffic light, reflective or flashing sign, or mirror ahead.

  • There is a temporary reflector or flash ahead from a construction area.

  • The road conditions are bad such as being wet, iced or covered with snow.

  • A vehicle suddenly appears from a curve.

  • The vehicle is tilted from a flat tire or is being towed.

  • Light from a vehicle is not detected because of smoke, fog, snow, or other obstructions.

WARNING
  • High Beam Assist may not turn off high beams every time. This function is for your convenience only. It is the responsibility of the driver to always check the road conditions and adjust headlights appropriately, including by using the manual controls. for your safety.

  • Intelligent Speed Limit Assist may not operate for 15 seconds after you start the vehicle or initialize or restart the front view camera.

  • If the high beam assistance is not operated properly, switch the headlights manually.