Operation

1. Open the driver's side door when the vehicle is stopped and the vehicle in ON position.

2. Move the seat forward as far as possible, and raise the seatback angle as forward as possible by using the driver's seat forward/backward adjustment switch and seatback angle adjustment switch.

3. Press the Driver 1 switch (1) from the driver position memory system and push the front portion of the driver's seat forward/backward adjustment switch (the direction to move the seat position forward) at the same time for approximately 2 seconds.

• The initialization process are as follows.

  • With a beep sound, the initialization process begins.

  • The seat and backrest automatically move to the rear. A beep sounds continuously during operation.

  • The seat and backrest will move to the center again and the initialization process will end with the last beep sound.

Non-operating condition(s)

The initialization process will be interrupted in the following situations.

• When any problem occurs in the driver position memory system

• When the driver position memory system button is pressed

• When the driver's side seat adjustment switch is pressed

• When the vehicle speed is above 3 km/h (2 mph)

• When the driver's side door is closed

If the driver's seat operation and a beep sound stop during initialization, start initialization again.

After initialization, adjust the seat to suit the driver and save it to the driving position memory system again.