Limitations of Blind-Spot Collision-Avoidance Assist

Blind-Spot Collision-Avoidance Assist may not operate properly, or it may operate unexpectedly under the following circumstances:

  • There is inclement weather, such as heavy snow and rain.

  • The detecting sensor is covered with snow, rain, dirt, etc.

  • The ambient temperature around the detecting sensor is high or low.

  • The detecting sensor is blocked while driving near a vehicle, pillar, or wall.

  • Driving on a highway ramp or through a tollgate.

  • The pavement abnormally contains metallic components (such as subway construction).

  • There are fixed objects near the vehicle, such as sound barriers, guardrails, central dividers, entry barriers, street lights, signs, tunnels, walls, etc.

  • Driving on a narrow road with overgrown foliage.

  • Driving in wide open areas where there are few vehicles or structures

  • Driving on a wet road surface.

  • Other vehicles are movin very close behind you, or are passing.

  • Oother vehicles are moving is very fast when passing.

  • You pass another vehicle.

  • You change lane.

  • Your accelerate at the same time as a vehicle next to you.

  • A vehicle in the next lane moves two lanes away from you, or when the vehicle two lanes away moves to the next lane from you

  • A trailer or carrier is installed around the rear corner radar

  • The bumper around the rear corner radar is covered with objects, such as a bumper sticker, bike rack, etc.

  • The bumper around the rear corner radar is impacted, damaged or the radar is out of position

  • Your vehicle height is low or high due to heavy loads, abnormal tire pressure, etc.

  • When the following objects are detected:

    • A motorcycle or bicycle is detected

    • A vehicle such as a flat-bed trailer is detected

    • A large vehicle such as a bus or truck is detected

    • A moving obstacle such as a pedestrian, animal, shopping cart or baby carriage is detected

    • A vehicle with low height such as a sports car is detected

Pay extra attention. Braking control may not operate under the following conditions:

  • The vehicle severely vibrates while driving over a bumpy road or pothole.

  • Driving on a slippery surface such as snow, water, ice, etc.

  • Tire pressure is low or is damaged

  • The braking system has been modified

  • When steering abruptly

WARNING
  • Driving on a curved road

    OMQ4053015
    OMQ4053016

    Blind-Spot Collision-Avoidance Assist may not operate properly on a curved road. Blind-Spot Collision-Avoidance Assist may not detect the vehicle in the next lane.

    Always pay attention to road and driving conditions.

    Blind-Spot Collision-Avoidance Assist may not operate properly when driving on a curved road.

    Always pay attention to road and driving conditions while driving.

  • Driving on an inclined road

    OMQ4053018_2

    Driving where the road is merging/dividing

    OMQ4053017

    Blind-Spot Collision-Avoidance Assist may not operate properly when driving on a slope. The function may not detect the vehicle in the next lane or may incorrectly detect the ground or structure.

    Always pay attention to road and driving conditions while driving.

    Blind-Spot Collision-Avoidance Assist may not operate properly when driving where the road merges or divides. The function may not detect the vehicle in the next lane.

    Always pay attention to road and driving conditions while driving.

  • Driving where the heights of the lanes are different

    OMQ4053019

    Always pay attention to road and driving conditions while driving.

    Blind-Spot Collision-Avoidance Assist may not operate properly when driving where the heights of the lanes are different. The function may not detect the vehicle on a road with different lane heights (underpass joining section, grade separated intersections, etc.).

WARNING
  • When you are towing a trailer or another vehicle, make sure that you turn off Blind-Spot Collision-Avoidance Assist.

  • Blind-Spot Collision-Avoidance Assist may not operate properly if interfered by strong electromagnetic waves.

  • Blind-Spot Collision-Avoidance Assist may not operate for approximately 3 seconds after the vehicle is started, or the front view camera or rear corner radars are initialized.