1. Turn the ignition switch and all other switches off.

2. Remove the fuse panel cover by pressing the tab and pulling the cover up. When the blade type fuse is disconnected, remove it by using the clip designed for changing fuses located in the engine room fuse box. Upon removal, securely insert reserve fuse of equal quantity.

   

3. Check the removed fuse; replace it if it is blown. To remove or insert the fuse, use the fuse puller in the engine compartment fuse panel.

4. Push in a new fuse of the same rating, and make sure it fits tightly in the clips. If it fits loosely, consult a professional workshop. Kia recommends to consult an authorized Kia dealer/service partner.

   

   CAUTION

   After checking the fuse panel in the engine compartment, securely install the fuse panel cover through the audible clicking sound.

   If not, electrical failures may occur from water contact.

If the multi fuse is blown, it must be removed as follows:

1. Disconnect the negative battery cable.

2. Remove the nuts shown in the picture above.

3. Replace the fuse with a new one of the same rating.

4. Reinstall in the reverse order of removal.

   

   NOTICE

   If the multi fuse is blown, consult a professional workshop. Kia recommends to consult an authorized Kia dealer/service partner.