Regenerative braking system: (if equipped)

Use the paddle shifters to adjust the regenerative braking level from 0 to 3 during deceleration.

N_SP327_C09_013
N_SP327_C00_268

The regenerative braking level will appear on the cluster.

In ECO mode, use the paddle shifters to adjust the regenerative braking level (levels 0–3 and MAX). This feature enhances driving enjoyment while improving energy efficiency.

  • Each time you pull the left paddle shifter, the regenerative braking level increases by one level and the vehicle decelerates more rapidly. Each time you pull the right paddle shifter, the regenerative braking level decreases by one level and the vehicle decelerates more gradually.

  • Pull and hold the left paddle shifter for approximately 0.4 seconds or more to activate MAX mode. The vehicle can be brought to a stop in MAX mode.

  • Pull and hold the right paddle shifter for approximately 1 second to turn the Smart Regeneration System on or off.

CAUTION
  • When the vehicle is started, the regenerative braking level is set to level 0. The regenerative braking system operates only when the vehicle is in D (Drive) and ECO mode is selected.

  • The regenerative braking mode is deactivated when the gear is shifted to P (Park), R (Reverse), N (Neutral), or manual shift mode, or when SPORT mode is selected. When the gear is shifted back to D (Drive), the previous regenerative braking level is restored.

  • The regenerative braking mode is deactivated when ABS or ESC operates.

  • The deceleration rate may vary depending on the vehicle speed, even at the same regenerative braking level. The difference is more noticeable during city driving, while the difference between levels may be less noticeable at high speeds.

  • While driving at approximately 1 mph (2 km/h) or higher, the regenerative braking level can be changed only when the brake pedal is not depressed.

  • When regenerative braking is deactivated, the vehicle deceleration rate may vary depending on the vehicle speed. Pay attention to the driving conditions and depress the brake pedal as necessary to control the vehicle speed.

NOTE
  • Coasting refers to driving using only the vehicle’s momentum without power by releasing both the accelerator pedal and the brake pedal.
  • Regenerative braking converts the vehicle’s kinetic energy into electrical energy using the drive motor during deceleration and uses this energy to charge the high voltage battery.

System limitation warning

Warning message

Display condition

Regenerative braking is limited because the battery is sufficiently charged

Regenerative braking is temporarily limited to protect the high voltage (hybrid) battery when its charge level is high.
  • Hydraulic braking using the brake pedal remains available.

  • Regenerative braking may remain limited for a longer period when the temperature of the high voltage (hybrid) battery is too low or too high.

Regenerative braking using the paddle shifters is unavailable

  • This warning message will appear when the motor or high voltage (hybrid) battery temperature is too high or too low, or when there is a problem with the high voltage (hybrid) battery or transmission.

  • This warning message will appear if you attempt to activate the regenerative braking mode while ABS, Cruise Control, or Smart Cruise Control is operating.

  • When this warning message appears, the regenerative braking function is temporarily limited. Drive the vehicle normally for a while, and then try using the function again.

Stopping the vehicle with the regenerative braking paddle shifter

N_SP327_C09_015

This function stops the vehicle while you pull and hold the left paddle shifter.

  • While driving, pull and hold the left paddle shifter for approximately 0.4 seconds or more.

  • During deceleration, the regenerative braking level will appear as MAX on the cluster. When the vehicle comes to a complete stop, STOP will appear.

  • When the regenerative braking level changes to STOP, the vehicle will remain stopped even if you release the left paddle shifter.
CAUTION
  • The function does not control the distance from the vehicle ahead.

  • The function may not bring the vehicle to a complete stop on a steep downhill road. Depress the brake pedal to stop the vehicle.

  • Always maintain a safe braking distance and depress the brake pedal to reduce speed if necessary.

  • The function is designed only for driver convenience and is not a safety system. The driver is responsible for safely operating and controlling the vehicle

    .
  • Before using the function, read the Owner’s Manual carefully and practice using the function to ensure safe operation.

  • Maintain a safe distance based on the vehicle speed and road conditions.

NOTE
  • When the regenerative braking level is STOP, depress the accelerator pedal to start driving again.

  • If you depress the brake pedal while the regenerative braking level is MAX, MAX control is maintained regardless of the paddle shifter operation. When the vehicle stops, the regenerative braking level changes to STOP.