1. Detach the speed restriction label (1) from the sealant bottle (2), and place it in a highly visible place inside the vehicle such as on the steering wheel to remind the driver not to drive too fast.

2. Filling the sealant Strictly follow the specified sequence, otherwise the sealant may escape under high pressure.

3. Shake the sealant bottle.

   

4. Connect the filling hose (3) onto the connector of the sealant bottle (2).

   

5. Ensure that button (9) on the compressor is not pressed.

6. Unscrew the valve cap from the valve of the defective wheel and screw filling hose (3) of the sealant bottle onto the valve.

7. Insert the sealant bottle into the housing of the compressor so that the bottle is upright.

8. Ensure that the compressor is switched off, position 0.

   
   

   CAUTION

   

   Securely install the sealant filling hose to the valve. If not, sealant may flow backward, possibly clogging the filling hose.

9. Connect between compressor and the vehicle power outlet using the cable and connectors.

   
   

   CAUTION

   Do not connect another vehicle's Tyre Mobility Kit (TMK) to the power outlet. The unmatched power requirement between the vehicle power outlet and the tyre mobility kit can cause fire or circuit damage within the vehicle and the Tyre Mobility Kit.

   

   NOTICE

   Only use the front passenger side power outlet.

10. With the ignition switched on or ENGINE START/STOP button position on: Switch on the compressor and let it run for approximately 3 minutes to fill the sealant. The inflation pressure of the tyre after filling is unimportant.

11. Switch off the compressor.

12. Detach the hose from the sealant bottle connector and from the tyre valve.

Return the Tyre Mobility Kit to its storage location in the vehicle.