Driver position memory system (for power seat) (if equipped)

A driver position memory system is provided to store and recall the driver seat position with a simple button operation. By saving the desired position into the system memory, different drivers can reposition the driver seat based upon their driving preference. If the battery is disconnected, the position memory will be erased and the driving position should be restored in the system.

WARNING

Never attempt to operate the driver position memory system while the vehicle is moving.

This could result in loss of control, and an accident causing death, serious injury, or property damage.

Storing positions into memory using the buttons on the door

Storing driver’s seat positions

Shift the shift lever into P or N while the ENGINE START/STOP button is ON.

Adjust the driver’s seat comfortable for the driver.

Press SET button on the control panel. The system will beep once.

Press one of the memory buttons (1 or 2) within 4 seconds after pressing the SET button. The system will beep twice when memory has been successfully stored.

Recalling positions from memory

Shift the shift lever into P or N while the ENGINE START/STOP button is ON.

To recall the position in the memory, press the desired memory button (1 or 2). The system will beep once, then the driver’s seat will automatically adjust to the stored position.

Adjusting the control switch for the driver’s seat while the system is recalling the stored position will cause the movement to stop and move in the direction that the control switch is moved.

WARNING

Use caution when recalling the adjustment memory while sitting in the vehicle. Push the seat position control switch to the desired position immediately if the seat moves too far in any direction.

Initializing Driver position memory system

Initialize Driver position memory system as follows if the system fails to function properly.

Initialization method

Have the vehicle completely stopped, the ignition [ON], and the shift lever placed into P (Parking). Afterwards, open the door on driver’s side.

Using the control switches for forward or backward and seatback angle, pull the seat forward to the fullest and the seatback upright forward to the fullest.

Press both [SET] button and the forward movement control switch at the same time for two seconds.

Initialization process

The alarm sounds and the initialization process starts.

The driver seat and its seatback automatically move backward. The alarm continues to sound during the movement.

The seat and seatback move to the center and the alarm sounds and the initialization is completed.

In the following cases, however, the initialization process and the alarming sound come to a stop.

Driving position memory system button is pressed
When the control switches for driver’s seat are pressed
When the shift lever was displaced from [P] to another position
When vehicle is ran at the speed of 3km/h or faster
When the door on the driver’s side is closed

WARNING

Re-start initialization if the alarming sound or initialization stop while the initialization is in process.
Make sure that nothing blocks the place near the driver seat before initializing Driver position memory system.
Once initialization is completed, make sure to adjust the seat to the driver’s preferences and remember the driving position.

Easy access function (if equipped)

The system will move the driver's seat automatically as follows:

It will move the driver’s seat rearward when the ENGINE START/STOP button is changed to the OFF position and front driver’s door is opened.
It will move the driver’s seat forward when the ENGINE START/STOP button is changed to the ACC or START position.

You can activate or deactivate this feature.

* For more details, refer to More Details or More Details.

NOTICE

If there’s not enough room between the driver seat and the rear seat or if the passenger is sitting right behind the driver seat, the driver seat can fail to move backward.