Limitations of High Beam Assist (HBA)

  • Light from another vehicle is not detected for any reason.

  • Headlamp of a vehicle is covered with dust, snow or water.

  • A vehicle’s headlamps are off, but the fog lamps are on, etc.

  • Your vehicle detects a lamp that is shaped like a vehicle headlight.

  • Headlamps have been damaged or not repaired properly.

  • Headlamps are not aimed properly.

  • You are driving on a narrow, curved, rough, or steep road.

  • You are driving on a crossroad or curved road and a vehicle in front of you is partially visible.

  • There is a traffic light, reflective or flashing sign, or mirror ahead.

  • There is a temporary reflector or flash ahead from a construction area.

  • The road conditions are bad such as being wet, iced or covered with snow.

  • A vehicle suddenly appears from a curve.

  • The vehicle is tilted from a flat tire or is being towed.

  • Light from a vehicle is not detected because of smoke, fog, snow, or other obstructions.

NOTE

For more information about the limitations of the front view camera, refer to Forward Collision-avoidance Assist (FCA) (Sensor Fusion).

WARNING

  • At times, High Beam Assist may not work properly. The function is for your convenience only. It is the responsibility of the driver for safe driving practices and always check the road conditions for your safety.

  • When High Beam Assist does not operate normally, change the headlamp position manually between high beam and low beam.