Wipers and washers


A: Wiper speed control
-
MIST – Single wipe
-
OFF – Off
-
INT – Intermittent wipe
AUTO* – Auto control wipe
-
LO – Low wiper speed
-
HI – High wiper speed
B: Intermittent control wipe time adjustment/Auto control wipe time adjustment*
C: Wash with brief wipes
D: Rear wiper/washer control
-
HI - Continuous wipe
-
LO - Intermittent wipe
-
OFF - Off
E: Wash with brief wipes (rear)
Windscreen wipers
Operate as follows when the ignition switch or ENGINE START/STOP button is ON.
-
MIST: For a single wiping cycle, move the lever to this position and release it. The wipers will operate continuously if the lever is held in this position.
-
OFF: Wiper is not in operation
-
INT: Wiper operates intermittently at the same wiping intervals. Use this mode in light rain or mist. To vary the speed setting, turn the speed control knob.
-
LO: Normal wiper speed
-
HI: Fast wiper speed

If there is heavy accumulation of snow or ice on the windscreen, defrost the windscreen for about 10 minutes, or until the snow and/or ice is removed before using the windscreen wipers to ensure proper operation. If you do not remove the snow and/or ice before using the wiper and washer, it may damage the wiper and washer system.