Wipers and washers
A: Wiper speed control (front)
-
MIST – Single wipe
-
OFF – Off
-
INT – Intermittent wipe
-
LO – Low wiper speed
-
HI – High wiper speed
B: Intermittent control wipe time adjustment
C: Wash with brief wipes (front)
D: Rear wiper/washer control
-
HI – Continuous wipe
-
LO – Intermittent wipe
-
OFF – Off
E: Wash with brief wipes (rear)
Windshield washers
Operates as follows when the ENGINE START/STOP button is turned ON.
MIST: For a single wiping cycle, move the lever to this (MIST) position and release it. The wipers will operate continuously if the lever is held in this position.
OFF: Wiper is not in operation
INT: Wiper operates intermittently at the same wiping intervals. Use this mode in light rain or mist. To vary the speed setting, turn the speed control switch.
LO: Normal wiper speed
HI: Fast wiper speed
If there is heavy accumulation of snow or ice on the windshield, defrost the windshield for about 10 minutes, or until the snow and/or ice is removed before using the windshield wipers to ensure proper operation. If you do not remove the snow and/or ice before using the wiper and washer, it may damage the wiper and washer system.
Do not use the washer in freezing temperatures without first warming the windshield with the defrosters; the washer solution could freeze on the windshield and obscure your vision.