Operating conditions

• This function will activate when backing up with the ENGINE START/STOP button ON.

• The function displays a warning on the instrument cluster or infotainment system and the warning sound is generated when an obstacle is detected.

• When more than two objects are sensed at the same time, the closest one will be recognized first.

Types of warning sound and indicator

Types of warning sound	Indicator
When an object is 60 cm ~ 120 cm from the rear bumper: Buzzer beeps intermittently
When an object is 30 cm ~ 60 cm from the rear bumper: Buzzer beeps more frequently.
When an object is within 30 cm of the rear bumper: Buzzer beeps continuously.

The detecting range may decrease when:

• The sensor is covered with foreign matter such as snow or water (The function will operate normally when such foreign material are removed.)

• The weather is extremely hot or cold

The following objects may not be detected:

• Sharp or slim objects such as ropes, chains or small poles

• Objects, which tend to absorb sensor frequency, such as clothes, spongy material or snow

• Objects smaller than 100 cm in length and narrower than 14 cm in diameter

Reverse Parking Distance Warning precautions

• Reverse Parking Distance Warning may malfunction if the vehicle bumper height or sensor installation has been modified or damaged. Any non-factory installed equipment or accessories may also interfere with the sensor performance.

• When the sensor is frozen or covered with snow, dirt, or water, the sensor may be inoperative until the material is removed using a soft cloth.

• Do not push, scratch or strike the ultrasonic sensor. Sensor damage could occur.

• Do not spray the ultrasonic sensors or its surrounding area directly with a high pressure washer.

NOTICE

Make sure that high pressure is not directly applied to the surface of the ultrasonic sensor while using use high-pressure car washes.

This function can only sense objects within the range and location of the sensors; It can not detect objects in other areas where sensors are not installed. Also, small or slim objects, such as poles or objects located between sensors may not be detected by the sensors.

Always visually check behind the vehicle when backing up.

Be sure to inform any drivers of the vehicle that may be unfamiliar with the function regarding the function's capabilities and limitations.

WARNING

Pay close attention when the vehicle is driven close to objects on the road, particularly pedestrians, and especially children. Be aware that some objects may not be detected by the sensors, due to the object's distance, size or material, all of which can limit the effectiveness of the sensor. Always perform a visual inspection to make sure the vehicle is clear of all obstructions before moving the vehicle in any direction.