To turn on Smart Cruise Control

• Press the Driving Assist () button to turn on Smart Cruise Control. The speed will be set to the current speed on the cluster.

• If there is no vehicle in front of you, the set speed will be maintained, but if there is a vehicle in front of you, the speed may decrease to maintain the distance to the vehicle ahead. If the vehicle ahead accelerates, your vehicle will travel at a steady cruising speed after accelerating to the set speed.

NOTICE

If your driving speed is between 0~ 30 km/h (0~ 20 mph) when you press the Driving Assist () button, Smart Cruise Control speed will be set to 30 km/h (20 mph).

To set vehicle distance

Each time the button is pressed, the Vehicle Distance changes as follows:

NOTICE

• If you drive at 90 km/h (56 mph), the distance is maintained as follows:

  Distance 4 - approximately 52.5 m (172 ft.)

  Distance 3 - approximately 40 m (130 ft.)

  Distance 2 - approximately 32.5 m (106 ft.)

  Distance 1 - approximately 25 m (82 ft.)

• The distance is set to the last set distance when the engine is restarted, or when Smart Cruise Control was temporarily canceled.

To increase set speed

• Push the + switch up and release it immediately. The set speed will increase by 1 km/h (1 mph) each time the switch is operated in this manner.

• Push the + switch up and hold it while monitoring the set speed on the cluster. The set speed will increase by 10 km/h (5 mph) each time the switch is operated in this manner. Release the switch when the desired speed is shown, and the vehicle will accelerate to that speed. You can increase the set speed to 180 km/h (110 mph).

WARNING

Check the driving condition before using the + switch. Driving speed may sharply increase when you push up and hold the + switch.

To decrease set speed

• Push the - switch down and release it immediately. The set speed will decrease by 1 km/h (1 mph) each time the switch is operated in this manner.

• Push the - switch down and hold it while monitoring the set speed on the cluster. The set speed will decrease by 10 km/h (5 mph) each time the switch is operated in this manner.

  Release the switch at the speed you want to maintain. You can decrease the set speed to 30 km/h (20 mph).

To temporarily cancel Smart Cruise Control

Press the switch or depress the brake pedal to temporarily cancel Smart Cruise Control.

Resuming Smart Cruise Control

To resume Smart Cruise Control after the function was canceled, operate the +, - or switch.

If you push the + switch up or - switch down, the set speed will be set to the current speed on the cluster.

If you press the switch, vehicle speed will resume to the preset speed.

WARNING

Check the driving condition before using the switch. Driving speed may sharply increase or decrease when you press the switch.

Turning off Smart Cruise Control

Press the Driving Assist () button to turn Smart Cruise Control off.

NOTICE

If your vehicle is equipped with Manual Speed Limit Assist, press and hold the Driving Assist () button to turn off Smart Cruise Control. However Manual Speed Limit Assist will turn on.

Based on Drive Mode

Smart Cruise Control will change acceleration based on the drive mode selected from Drive Mode Integrated Control system. Refer to the following chart.

NOTICE

• For more details on Drive Mode, refer to More Details.

• Smart Cruise Control may not turn on or off in some of the drive modes for the operating conditions are not satisfied.

• For the vehicle without the Drive Mode, acceleration of Smart Cruise Control is set to 'Normal'.