Plug & Charge (Automatic Billing Charging)
The Plug & Charge feature allows for faster and more convenient vehicle charging by automatic billing when using DC chargers.
Setting Plug & Charge

To enable the Plug & Charge feature for automatic billing during DC charging, Select EV → EV Settings → Plug & Charge and enable Plug & Charge.

If you haven't signed a contract, keeping the Plug & Charge feature turned off is advisable. Using the Plug & Charge feature without a contract may lead to issues during charging.
Renew the Plug & Charge
If Plug & Charge isn't working or fails during charging, check your contract certificate's expiration and renewal status.
-
If the certificate expires, automatic billing charging won't proceed.
-
It is recommended to turn off the Plug & Charge feature until the certificate status is confirmed. If automatic billing fails twice, external payment will be used on the third attempt.
After payment switches to external payment, you can still re-enable the Plug & Charge feature and utilize the Automatic Billing Charging function by following one of the methods outlined below
-
After completing one charging session using external payment, you can utilize the Plug & Charge automatic billing method for next sessions.
-
Disconnect the charging connector, close the charging door, leave the vehicle in 'Ready' mode for over a minute, then you can start Plug & Charge charging.
-
Use a different charger that supports the Plug & Charge feature.
If the contract certificate for Plug & Charge charging expires or is revoked, follow these steps:
-
Sign a new contract to issue or renew the certificate.
-
Connect the charging connector and attempt Plug & Charge charging once.
-
The charger will display the expiration date and revocation status of the certificate and fail to charge.
-
-
Disconnect and reconnect the charging connector, then attempt Plug & Charge charging again.
-
Once the certificate for the new contract is installed, Plug & Charge charging will proceed normally.
-
Managing Plug & Charge Contracts
When a contract certificate is installed during Plug & Charge charging, the contract management menu in the Plug & Charge settings screen becomes active. To review and manage contract information:
-
Select EV → EV Settings → Plug & Charge to open Contract Management menu.
-
Review the displayed contract information and expiration date (year/month).
-
If necessary, press Delete to remove a contract certificate.
-