• Once you set the ENGINE START/STOP button to the ON position.

  • It illuminates for approximately 3 seconds and then goes off.

• When there is a malfunction with the ESC system.

  In this case, have the vehicle inspected by a professional workshop. Kia recommends to visit an authorized Kia dealer/service partner.

While the ESC is operating.

* For more details, refer to “Electronic Stability Control (ESC)” in chapter 5.

• Once you set the ENGINE START/STOP button to the ON position.

  • It illuminates for approximately 3 seconds and then goes off.

• When you deactivate the ESC system by pressing the ESC OFF button.

* For more details, refer to “Electronic Stability Control (ESC)” in chapter 5.

• When the vehicle detects the smart key in the vehicle properly while the ENGINE START/STOP button is ACC or ON.

  • At this time, you can start the engine.

  • The indicator light goes off after starting the engine.

• When the smart key is not in the vehicle.

  • At this time, you can not start the engine.

• When the vehicle can not detect the smart key which is in the vehicle while the ENGINE START/STOP button is ON.

  In this case, have the vehicle inspected by a professional workshop. Kia recommends to visit an authorized Kia dealer/service partner.

• When the battery of the smart key is weak.

  • At this time, you can not start the engine.However, you can start the engine if you press the ENGINE START/STOP button with the smart key. (For more details, refer to “Starting the Engine” in chapter 5).

• When there is a malfunction with the immobilizer system.

  In this case, have the vehicle inspected by a professional workshop. Kia recommends to visit an authorized Kia dealer/service partner.

• When you switch on the turn signal light on.

If any of the following occurs, there may a malfunction with the turn signal system. In this case, have the vehicle inspected by a professional workshop. Kia recommends to visit an authorized Kia dealer/service partner.

• The indicator light does not blink but illuminates.

• The indicator light blinks more rapidly.

• The indicator light does not illuminate at all.

• When the headlights are on.

• When the headlights are on and in the high beam position

• When the turn signal lever is pulled into the Flash-to-Pass position.

• When the tail lights or headlights are on.

• When the rear fog lights are on.

• When the front fog lights are on.

• When the high-Beam is on with the light switch in the AUTO light position.

• If your vehicle detects oncoming or preceding vehicles, the high beam assist system will switch the high beam to low beam automatically.

* For more details, refer to “High beam assist” in chapter 4.

• [White] When you activate the auto hold system by pressing the AUTO HOLD button.

• [Green] When you stop the vehicle completely by depressing the brake pedal with the auto hold system activated.

• [Yellow] When there is a malfunction with the auto hold system.

  In this case, have the vehicle inspected by a professional workshop. Kia recommends to visit an authorized Kia dealer/service partner.

* For more details, refer to “Auto Hold” in chapter 5.

• When you select “ECO” mode as drive mode.

* For more details, refer to “Drive Mode Integrated Control System” in chapter 5.

• When you select “SMART” mode as drive mode.

* For more details, refer to “Drive Mode Integrated Control System” in chapter 5.

• Once you set the ENGINE START/STOP button to the ON position.

  • It illuminates for approximately 3 seconds and then goes off.

• When you select AWD Lock mode by pressing the AWD LOCK button.

  • The AWD LOCK mode is to increase the drive power when driving on wet pavement, snow covered roads and/or off-road.

CAUTION

AWD Lock Mode

Do not use AWD LOCK mode on dry paved roads or highway, it can cause noise, vibration or damage of AWD related parts.