Wipers and washers

The wipers and washers remove foreign substances from the windshield and rear window, helping to maintain visibility.

Front windshield wiper/washer

Rear windshield wiper/washer

A: Wiper speed control (front)

MIST – Single wipe
OFF – Off
INT – Intermittent wipe
LO – Low wiper speed
HI – High wiper speed

B: Intermittent control wipe time adjustment

C: Wash with brief wipes (front)^*

D: Rear wiper/washer control^*

HI – Continuous wipe
LO – Intermittent wipe^*
OFF – Off

E: Wash with brief wipes (rear)^*

* if equipped

Windshield washers

Operates as follows when the POWER button is turned ON.

MIST: For a single wiping cycle, move the lever to this (MIST) position and release it. The wipers will operate continuously if the lever is held in this position.

OFF: Wiper is not in operation

INT: Wiper operates intermittently at the same wiping intervals. Use this mode in light rain or mist. To vary the speed setting, turn the speed control switch.

LO: Normal wiper speed

HI: Fast wiper speed

NOTICE

If there is heavy accumulation of snow or ice on the windshield, defrost the windshield for about 10 minutes, or until the snow and/or ice is removed before using the windshield wipers to ensure proper operation. If you do not remove the snow and/or ice before using the wiper and washer, it may damage the wiper and washer system.

Contains Topics: Operating windshield washer; Operating rear window wiper and washer switch