Detecting sensors
The rear corner radars are located inside the rear bumper for detecting the side and rear areas. Always keep the rear bumper clean for proper operation of the function.
-
Blind-Spot Collision Warning may not work properly when the bumper has been damaged, or if the rear bumper has been replaced or repaired.
The sensing range differs somewhat according to the width of the road.
-
When the road is narrow, the function may detect other vehicles in the next lane.
-
The function may turn off if interfered by electromagnetic waves.
-
Always keep the sensors clean.
-
NEVER disassemble the sensor component or apply any impact on the sensor component.
-
Be careful not to apply unnecessary force on the radar sensor or sensor cover. If the sensor is forcibly moved out of proper alignment, the function may not operate correctly. In this case, a warning message may not be displayed. Have the vehicle inspected by an authorized Kia dealer/service partner.
-
Do not apply foreign objects such as a bumper sticker or a bumper guard near the radar sensor or apply paint to the sensor area.
Doing so may adversely affect the performance of the sensor.
Warning message
Blind-Spot Collision Warning (BCW) system disabled. Radar blocked
This warning message may appear when:
-
One or both of the sensors on the rear bumper is blocked by dirt or snow or a foreign object.
-
Driving in rural areas where the sensor does not detect another vehicle for an extended period of time.
-
When there is inclement weather such as heavy snow or rain.
If any of these conditions occur, the function will turn off automatically.
Turn off Blind-Spot Collision Warning and Rear Cross-Traffic Collision Warning when a trailer or carrier is installed.
-
Deactivate Blind-Spot Collision Warning by deselecting 'User Settings → Driver Assistance → Blind-Spot safety → Off' in the cluster
-
Deactivate Rear Cross-Traffic Collision Warning by deselecting 'User Settings → Driver Assistance → Parking Safety → Rear Cross-Traffic Safety' in the cluster or infotainment function display.
When Blind-Spot Collision Warning canceled warning message is displayed in the cluster, check to make sure that the rear bumper is free from any dirt or snow in the areas where the sensor is located. Remove any dirt, snow, or foreign material that could interfere with the radar sensors.
After any dirt or debris is removed, the function should operate normally after about 10 minutes of driving the vehicle.
If the function still does not operate normally have your vehicle inspected by an authorized Kia dealer/service partner.
Check Blind-Spot Collision Warning (BCW) system
If there is a problem with Blind-Spot Collision Warning, a warning message will appear.
The function will turn off automatically. We recommend that you have your vehicle inspected by an authorized Kia dealer/service partner.