Using the Tyre Mobility Kit
1
Detach the speed restriction label (1) from the sealant bottle (2), and place it in a highly visible place inside the vehicle
such as on the steering wheel to remind the driver not to drive too fast.
2
Filling the sealant Strictly follow the specified sequence, otherwise the sealant may escape under high pressure.
3
Shake the sealant bottle.
4
Connect the filling hose (3) onto the connector of the sealant bottle (A).
5
Ensure that button (9) on the compressor is not pressed.
6
Unscrew the valve cap from the valve of the defective wheel and screw filling hose (3) of the sealant bottle onto the valve.
7
Insert the sealant bottle into the housing of the compressor so that the bottle is upright (B).
8
Ensure that the compressor is switched off, position 0.
9
Connect between compressor and the vehicle power outlet using the cable and connectors.
NOTICE
Only use the front passenger side power outlet.
10
With the ignition switch or ENGINE START/STOP button position on: Switch on the compressor and let it run for approximately
3 minutes to fill the sealant. The inflation pressure of the tyre after filling is unimportant.
11
Switch off the compressor.
12
Detach the hose from the sealant bottle connector and from the tyre valve.