Search by Title only
Home > Safety features of your vehicle > SEATS > Headrest (for front seat)

Headrest (for front seat)

The driver's and front passenger's seats are equipped with a headrest for the occupant's safety and comfort.

The headrest not only provides comfort for the driver and front passenger, but also helps protect the head and neck in the event of a collision.

WARNING

  • For maximum effectiveness in case of an accident, the headrest should be adjusted so the middle of the headrest is at the same height of the center of gravity of an occupant's head. Generally, the center of gravity of most people's head is similar with the height of the top of their eyes. Also, adjust the headrest as close to your head as possible. For this reason, the use of a cushion that holds the body away from the seatback is not recommended.

  • Do not operate the vehicle with the headrests removed. Severe injury to the occupants may occur in the event of an accident. Headrests may provide protection against neck injuries when properly adjusted.

  • Do not adjust the headrest position of the driver’s seat while the vehicle is in motion.

Adjusting the height up and down

To raise the headrest, pull it up to the desired position (1). To lower the headrest, push and hold the release button (2) and lower the headrest to the desired position (3).

Forward and backward adjustment (if equipped)

The headrest may be adjusted forward to 3 different positions by pulling the headrest forward to the desired detent.

To adjust the headrest to it’s furthest backwards position,

Pull the headrest fully forward to the farthest position and release it.

Adjust the headrest so that it properly supports the head and neck.

CAUTION

If you recline the seatback towards the front with the headrest and seat cushion raised, the headrest may come in contact with the sun visor or other parts of the vehicle.

Removal/Reinstall

Type A
Type B

To remove the headrest:

  1. Recline the seatback (2) with the recline dial or switch (1).

  2. Raise headrest as far as it can go.

  3. Press the headrest release button (3) while pulling the headrest up (4).

    WARNING

    NEVER allow anyone to ride in a seat with the headrest removed or reversed.

Type A
Type B

To reinstall the headrest:

  1. Put the headrest poles (2) into the holes while pressing the release button or switch (1).

  2. Recline the seatback(4) with the recline dial or switch (3).

  3. Adjust the headrest to the appropriate height.

    WARNING

    Always make sure the headrest locks into position after reinstalling and adjusting it properly.