1. Detach the speed restriction label (1) from the sealant bottle (2), and place it in a highly visible place inside the vehicle such as on the steering wheel to remind the driver not to drive too fast.

   

Carefully follow below steps.

1. Shake the sealant bottle.

   

2. Connect the filling hose (3) onto the connector of the sealant bottle (A). Then, connect the sealant bottle connection to compressor (B).

   

3. Ensure that button (9) on the compressor is not pressed.

4. Unscrew the valve cap from the valve of the flat tire and screw filling hose (3) of the sealant bottle onto the valve.

   

5. Insert the sealant bottle into the housing (5) of the compressor so that the bottle is upright.

6. Ensure that the compressor is switched off, position 0.

   

   CAUTION

   Securely install the sealant filling hose to the valve. If not, sealant may flow backward, possibly clogging the filling hose.

   
   

   NOTICE

   If the sealant is injected when the tire air pressure injection valve and sealant injection hose are not fully interlocked, the sealant may overflow and clog the valve.

7. Connect between compressor and the vehicle power outlet using the cable and connectors.

   

8. With the POWER button ON position and let it run for approximately 5~7 minutes to fill the sealant up to cold tire recommended pressure. (refer to More Details). The inflation pressure of the tire after filling is unimportant and will be checked/corrected later.

   Be careful not to overinflate the tire and stay away from the tire when filling it.

When the tire and wheel are damaged, do not use Tire Mobility Kit for your safety.

1. Switch off the compressor.

2. Detach the hoses from the sealant bottle connector and from the tire valve.

Return the TMK to its storage location in the vehicle.